Asterisk and Chan-SCCP Installation

I’ve worked a little on Asterisk and have a bit of interest on getting Chan-SCCP working so a Cisco 79XX series IP phone will run natively with it as a very cost affective VoIP Pbx.

I’ve put together a small howto on the initial configuration steps that are recommended (primarily for myself so I don’t have to re-learn it the next time I build one!) for both security and the inclusion (compiling) of the current release of Chan-SCCP (which is at V3-RC3 as I write).

Attached is the Howto and some sample configuration files for Asterisk.

Asterisk Trixbox Initial Configuation, Security and Chan_SCCP

sccp samples

This entry was posted in Asterisk VoIP. Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *